Kenworth — Kenworth T170 T270 T370 and Hybrid 2011 Body Builders Manual

Section 7 Frame Modifications WARNING: Do not drill new holes any closer than 2 inches (50 mm) to existing holes. Frame drilling affects the strength of the rails and if not done properly can cause the frame rails to fail and cause an accident. Before the rear suspension is relocated, check the new location of the spring hanger brackets. The new holes for the spring hanger brackets must not overlap existing holes and should not come any closer than 2 inches (50 mm) to existing holes.

Mount the suspension Brackets On the Original Rail (see frame insert section & figures 7-1 & 7-2) Extended Wheelbase Do Not Mount the Suspension Bracket On the Added Frame Rail Original Wheelbase Relocated Rear Suspension Shortened Wheelbase Cut Frame at Rear to Obtain Desired Cutoff FIGURE 7-3. Comparison of Original, Shortened, and Extended Wheelbases Crossmembers After changing a wheelbase, an additional crossmember may be required to maintain the original frame strength. The maximum allowable distance between adjacent crossmembers is 60 inches (1524 mm). If the distance between adjacent crossmembers exceeds this dimension, add a crossmember between them. See Figure 7–4.

Before Wheelbase is Lengthened FIGURE 7- 4. Crossmember Added when Distance Exceeds 60 inches (1524 mm) 7-4 12//11 ss Than 60” r Than 60” al Crossmember