Section 8 Electrical The instrument panel is installed with two screws. FIGURE 8-6. Main Instrument Panel CVSG Gauges The 2” gauges located to the left and right of the main instrument panel are commonly referred to as Commercial Vehicle Smart Gauges (CVSG). Like the central instrument cluster, the 2-inch gauges also receive input data directly from the CECU. CVSG’s are two types, electronic and mechanical. The electronic CVSG’s receive digital data from the CECU via the CVSG data bus. The mechanical gauges (i.e. suspension air pressure, etc.) are driven directly from the air pressure.
Both types of gauges receive backlighting signals from the CECU via a 4-wire “daisy chained” jumper harness that links one gauge to another. When the ignition key is first turned ON, all the electronic 2-inch gauges will perform a calibration “power on self-test”. Note: The mechanical CVSG do not perform a power on self-test. Power On Self-Test Ignition key turned ON The gauge pointers move from pointing at zero, counter-clockwise to their mechanical limit (approx.
-5°), stay there for one second and go back to pointing at zero At the same time, all telltales in DWIM and main gauges are switched on together, and then switched off together Additional CVSG gauge information body builders should be aware of: The CECU sends gauge information to CVSGs over a data link (blue wire) between the CECU and the gauge (calle CVSG bus) CVSG gauges get their power from the CECU Yellow = Power wire (9-16 volts) White = Ground (return) wire 8-5 12/11