Section 9 Routing Wires Crossing other Components Electrical wires crossing over other components, such as lines, bolt heads, fittings, engine components lifting eyes, engine block, cylinder head, etc., close enough to rub shall be isolated with a covering of convoluted tubing and separated from the component by using butterfly clamps, butterfly ties, or plastic sheathing. 110/220 volt engine heater wiring shall be installed with butterfly ties or butterfly clamps. Piping Use no street elbows in air brake, water, fuel, or hydraulic systems unless specified on the piping diagram and the build instructions.
Use no elbows in the air brake system unless specified on the air piping diagram and the build instructions. Hoses Crossing Components Hoses crossing over other components close enough to rub shall be protected with a secured covering of convoluted plas- tic tubing (KW part number K344-813), another section of hose, or plastic sheathing (KW part number K213-1312). The usage of butterfly ties, or butterfly clamps are also recommended. Air Compressor Discharge Hoses Wires or hoses shall not be tied to the high temperature air compressor discharge hose.
Hoses and wires may be routed across the air compressor discharge hose at a distance of 18 inches (457 mm) or greater from the compressor discharge port. In this case the crossing hoses and wires shall be “butterfly” clamped to the air compressor discharge hose and cov- ered with convoluted tubing at the clamp point (use high temperature clamps on the compressor hose). Bundles HD mount and tie strap, or clamp shall be located at intervals not to exceed 14 inches (356 mm) along the bundle. Regular tie straps shall be located at intervals not to exceed 7 inches (178 mm) between HD mount or clamps. Extra tie straps may be used as needed to contain the hoses and wires in the bundle.
Routing of Wires and Hoses near Moving Components Wires and Hoses shall be routed away from moving components, such as fans, shackle links, drivelines, steering linkages, etc. so that there is at least 0. 5 inches (12. 7 mm) clearance when the component is operating at its maximum travel limits. A minimum clearance of 1. 0 inchs (25. 4) shall be maintained between steering axle tires (and associated rotating parts) in all positions and routed components, such as hoses, oil lines, wires, pipes, etc. 9-3 12/11