OPERATION LOAD HANDLING SAFETY TIPS The following explanation of the method of operating the forklift does not cover all situations. The operating method differs according to each operating condition. When operating the forklift, use the safest and most efficient method. The operating speed of the forklift is determined according to the configuration of the ground, condition under foot, and size of the operating area. Always travel at a safe controllable speed. Be aware of the fork tip protrusion when handling a load, damage to materials in front of your load may result if not careful when placing materials back to back.
When operating the forklift, maintain the engine speed at near full speed, and carry out the operation with the speed range in 1st or 2nd. Use 3rd or 4th speed when traveling without a load. TRAVELING SAFETY TIPS When traveling with a load, do not turn suddenly or accelerate or decelerate suddenly. There is danger that the load will fall off or the machine or may cause a rollover situation. Travel with the load no higher than 305 mm (12 in) off the ground and tilted back slightly. Never raise a load while traveling, always stop to raise a load and proceed cautiously. The fork tilt angle differs according to the load.
If loads are stacked on top of each other, and the tilt angle is excessive, there is danger that the top load will extend over the backrest of the carriage and slip to the rear. When traveling with out a load, travel with the forks 305 mm (12 in) off the ground. LOADING OPERATIONS 1. Adjust the distance between the forks to match the size of the load. 2. Drive slowly toward the load with the forks 305 mm (12 in.) off the ground, when with in 152 mm (6 in.) of the load raise the forks up to the proper height to pick up the material. To ensure the stability of the load, set the distance between the forks as wide as possible. Be sure the load is centered on the forks. 3.
Roll the carriage forward so the forks are level with the load. Carefully approach the load. 4. Drive into the load until the material is touching the load back rest on the carriage. Remark Always be aware of the fork tip protrusion when entering a load, the fork tips may damage material stacked behind the load you are picking up 5. Once in the load, raise the forks so the load just touches the top surface of the forks, 2-62 WA320PT-5L