OPERATION TRANSPORTING A LOAD When traveling with a load, do not turn suddenly or accelerate or decelerate suddenly. There is a danger the load will fall off or the machine could rollover. The fork tilt angle differs according to the load. If loads are stacked on top of each other, and the tilt angle is excessive, there is a danger the top load will extend over the backrest of the carriage and slip on to the rear loader arms or wheels. Keep the load near the ground surface 305 mm (12 in) when transporting. When transporting a load, carry out the operation with the speed range in 1st or 2nd. Use 3rd or 4th speed when traveling without a load.
The travel speed when transporting differs according to the conditions. Always travel at a safe controllable speed that ensures safety. When transporting on rough ground or slopes, travel at low speed. When transporting on slopes, travel with the load on the uphill side. If the load obstructs the view to the front, travel facing in reverse. UNLOADING 1. Approach the drop site slowly and stop when 152 mm (6 in) in front of your drop area. Remark Be aware of the fork tip protrusion when setting a load, the fork tips may damage material stacked behind the load you are placing 2.
With the load in line of the drop zone, raise it above the surface you intend to place it and proceed slowly and cautiously. 3. Once over the drop area, stop and roll the carriage forward until it is level with the surface. 4. Lower the load carefully onto the stack or drop area. 2-64 WA320PT-5L