2. Set the attachment selector switch to bucket position (a) OPERATION 3. Loosen 2 bolts (1), adjust the position of mounting bracket (4) of the proximity switch so that the rear tip of bar (2) is in line with the center of the sensing surface of proximity switch (3), then tighten bolts to hold the bracket in position. 4. Loosen 2 nuts (6), adjust so that clearance (A) between support (5) and the sensing surface of proximity switch (3) is 0.5 to 1.0 mm (0.020 to 0.039 in), then tighten the nuts to hold in position. Tightening torque: 14.7 to 19.6 NІm (10.8 to14.5 lbft) 5.
Loosen 2 bolts (7), adjust so that clearance (B) between bar (2) and the sensing surface of proximity switch (3) is 3 to 5 mm (0.118 to 0.197 in), then tighten the bolts to hold in position. 5. After adjusting, start the engine and raise the lift arm. Operate the bucket control lever to the DUMP position, then oper- ate it to the TILT BACK position and check that the lever is automatically returned to the HOLD position when the bucket reaches the desired digging angle. BUCKET LEVEL INDICATOR (A) and (B) at the top rear of the bucket are the level indicators, so the bucket angle can be checked during operations. (A): Parallel with cutting edge (B):
90 degrees to cutting edge ADJUSTING FORK POSITIONER 1. Lower the forks to the ground, set to the horizontal position, return the work equipment control lever to the HOLD position, then set the work equipment lock lever to the LOCK position and stop the engine. WA320PT-5L 2-67