OPERATION USING THE HYDRAULIC QUICK COUPLER Before operating the machine, check to be sure the attachment is correctly connected. If it is not correctly installed, the attachment may fall off and cause serious injury. Check that the quick coupler attachment switch is at the CONNECT position. Check that the coupler plunger is completely inserted into the attachment. REMOVING THE ATTACHMENT 1. Tilt the attachment. 2. Keep the bucket control lever at the TILT position, pull lock (A) of the quick coupler attachment switch in the direction of the arrow (c), and push in to RELEASE position (a) to release the connection. 3. Check that the coupler plunger is completely pulled in. 4.
Lower the attachment completely to the ground and set it in a stable position. WA320PT-5L 2-69