Komatsu — TURNING ON SLOPES

OPERATION CHANGING DIRECTION When changing direction between FORWARD and REVERSE , be sure the direction of travel you will be using is safe. and there are no blind spot behind or beside the machine, be aseptically careful when changing direction to travel in reverse. Do not switch between FORWARD and REVERSE when traveling at high speeds. Always bring the machine to a full stop or slow down before changing direction. When switching between FORWARD and REVERSE , depress the brake to reduce the travel speed sufficiently, then change the direction of travel. (Max.speed for changing direction:

13 km/h (8.1 MPH)) TURNING THE MACHINE Turning the steering wheel suddenly at high speed or turning on steep slopes is dangerous. Do not turn the steering wheel in such situations. If the engine stops when the machine is traveling, the steering force will become heavy, so never stop the engine while traveling. It is particularly dangerous if the engine stops when the machine is traveling on slopes, never let the engine stop when traveling on slopes. If the engine should stop suddenly, stop the machine immediately in a safe place. When traveling, and turning the machine. Keep in mind the front frame is joined to the rear frame at the center of the machine by the center pin.

Therefore, the front and rear frames bend at this point, and the rear wheels follow in the same track as the front wheels when turning. When turning, turn the steering wheel carefully to follow the machine as it turns. Remark When the steering wheel reaches the end of its stroke, do not try to turn it any further. Check the play it should be 50 to 100 mm (2.0 to 3.9 in) in the steering wheel. If any abnormality is found, contact your Komatsu dealer for inspection. TURNING ON SLOPES Traveling on slopes is dangerous in general. However, turning on a slope can be fatal. When traveling on a slope never turn the steering wheel. Always travel straight up or straight down a slope.

If the machine should start to tip, lower the bucket to the ground immediately to stabilize the machine. Travel at a slow pace in the lower speed ranges, avoid dragging the brakes when traveling down a slope. WA320PT-5L 2-75