5. Lower the lift arm and bucket to the ground. OPERATION 6. Set safety lock lever to the LOCK position. 7. A llow the engine to run at a low idle for about 5 minutes to cool down gradually. Never shut down an engine that is over heating or has just finished work operations always allow it a time to cool down before turning the ignition key to the “OFF” position. 8. Always lock the following areas. (1) Fuel filler cap (2) Rear grill (3) Engine side cover (2 places) (4) Cab door (2 places) Remark The ignition switch key is used also for locks (1), (2), (3) and (4). WA320PT-5L 2-79