MAINTENANCE CHASSIS Problem Main Cause Remedy HST Axle Brakes Parking Brake Steering Hydraulic System WA320PT-5L 3-3 Engine is running, in F or R position bud foes not move • Parking brake is applied • Directional lever is not shifted properly • Electrical problem • Lack of oil in tank • Release parking brake fully • Shift lever properly • Check fuse or electrical system • Add oil as needed Even when engine is running at full throttle the machine lacks power • Lack of oil in hydraulic tank • Hydraulic temperature too low • Add oil to proper level • Warm machine up Oil overheats • Too much or too little oil • Clogged oil cooler • Add or drain oil • Clean oil cooler Noises are heard in system • Lack of transfer oil • Add oil to specified level Noises are heard in axle • Lack of oil • Improper oils used • Add oil to specified level When pedal is depressed the brakes do not work • Disc has reached wear limit • Defective hydraulic system • Air in the system • Reline and replace disks • Add oil to specified level • Bleed air from system Brakes drag • Defective adjustment • Vent hole in brake valve is plunged • Check and repair Brakes squeal • Disk is worn • Water mixed in the oil • Deteriorate oil • Reline and replace disks • Replace with fresh oil Parking brake will not hold machine • Linkage is loose • Disk is worn • Adjust • Replace disk Steering effort is heavy • Defective hydraulic system • Lack of oil • Add oil to specified level Excessive play in steering wheel • Steering cylinder pin is loose • Defective hydraulic system • Grease or replace pin • Add oil to specified level Work equipment lacks lifting power Work equipment is slow • Lack of oil • Clogged filter • Add oil to specified level • Replace filter