MAINTENANCE CLEANING TRANSFER OIL COOLER FINS If compressed air, high-pressure water, or steam hits your body directly or dirt is sent flying by the compressed air, high-pressure water, or steam, there is danger of personal injury. Always wear protective glasses, dust mask, and other protective equipment. Clean the oil cooler if mud or dirt is stuck to it. 1. Remove cover (1). 2. Use compressed air to clean the mud, dust, and leaves from the oil cooler fins (2). Steam or water may be used instead of compressed air. 3. After cleaning, install the cover (1).
Remark If the steam jet nozzle is brought too close to the oil cooler fins, it may damage the fins, so keep the nozzle a suitable distance away from the fins when cleaning. CHECKING ELECTRICAL INTAKE AIR HEATER Before the start of the cold season (once a year), contact your Komatsu Dealer to have the electrical intake air heater checked for dirt or disconnections. REPLACING BOLT ON CUTTING EDGE It is extremely dangerous if the work equipment moves when carrying out the turning or replacement operation. Set the work equipment in a stable position, stop the engine, then set the safety lock lever securely to the LOCK position.
Turn or replace the cutting edge before the wear reaches the edge of the bucket. 1. Raise the bucket to a suitable height, then put blocks (A) under the bucket to prevent the bucket from coming down. Raise the bucket so that the bottom surface of the bucket is horizontal. 2. Remove nuts and bolts (1), then remove cutting edge (2). 3. Clean the mounting surface of cutting edge (2). 4. Turn cutting edge (2) and install it to the bucket. When turning the edge, install it to the opposite side (left edge to right side, right edge to left side). If both sides of the cutting edge are worn, replace with a new part.
If the wear extends to the mounting surface, repair the mounting surface before installing the cutting edge. 5. Tighten nuts and bolts (1) uniformly so that there is no gap between the bucket and cutting edge. Tightening torque for mounting bolt: 883 to 1196 Nm (90 to 122 kgfm (651 to 882 ft/lbs) 6. Tighten the mounting bolts again after operating for several hours. 3-24 WA320PT-5L