Komatsu — REPLACING ENGINE OIL FILTER CARTRIDGE

MAINTENANCE REPLACING ENGINE OIL FILTER CARTRIDGE Container to catch the oil Filter wrench 1. Open the engine side cover on the right side of the chassis. 2. Set the container to catch the fuel under the filter cartridge. 3. Using a filter wrench, turn filter cartridge (1) counterclockwise to remove it. 4. Clean the filter holder, fill a new filter cartridge with clean fuel, coat the packing surface with engine oil, then install it to the filter holder. Add fuel from small hole (A) (dirty side) at eight places. Do not add fuel from hole (B) (clean side) at the center. Remark If the filter cartridge is tightened excessively, the packing will be damaged and fuel will leak.

If the filter cartridge is too loose, fuel will also leak from the packing, so always tighten to the correct amount. 5. When installing, screw in cartridge until seal comes in contact with sealing surface, then tighten approx. an additional 1/2 turn. 6. Add fuel to the fuel tank until full (to “FULL” mark on the fuel gauge). 7. Loosen air bleed plug (2). 8. Loosen the knob of feed pump (3), then pump it up and down until no more bubbles come out with the fuel from air bleed plug (2). 9. After bleeding the air, tighten air bleed plug (2), then push in the knob of priming pump (3) and tighten it. Tightening torque for air bleed plug: 7.8 to 11.8 Nm (5.8 to 8.7 ft/lbs) 10.

After bleeding the air, start the engine and check that there is no fuel leakage from the filter seal surface. If there is any leakage, check the tightening of the filter cartridge. If there is still leakage, follow Step 2 and 3 to remove the filter cartridge, then check the packing surface for damage or foreign material. If any damage or foreign material is found in the packing, replace the cartridge with a new part, then repeat Steps 4 - 7 to install the filter cartridge. 3-38 WA320PT-5L