MAINTENANCE REPLACING HST OIL FILTER ELEMENT The parts and oil are at high temperature. Wait for the temperature to go down before starting the work. When removing the oil filler cap, turn it slowly to release the internal pressure, then remove it. 1. Remove cover (1). 2. Using a filter wrench, turn filter cartridge (2) to the left to remove. 3. Install the new filter cartridge. Tightening torque: 29 to 39 Nm (21.7 to 28.9 ft/lbs) 4. Run the engine at low idling for 5 minutes to bleed the air from the HST circuit. 5. Check the hydraulic oil level. 6. Run the engine at low idling, and extend and retract the steering, bucket, and lift arm cylinders 4 to 5 times.
Be careful not to operate the cylinder to the end of its stroke stop approx.100 mm (3.9 in) before the end of stroke. 7. Next, operate the steering, bucket, and lift arm cylinders to the end of their stroke 3 to 4 times, then stop the engine and loosen filler cap to bleed the air from the hydraulic tank. Check the hydraulic oil is at the specified level. 8. After completing the operation, install cover (2). Replace the HST filter element if the HST oil filter clogging warning pilot lamp lights up, even if 1000 hours or 1 year has not passed. LUBRICATING CHASSIS 1. Using a grease pump, pump in grease through the grease fittings marked by the arrows. 2.
After greasing, wipe off any old grease that was pushed out. (1) Center hinge pin (2 places) (2) Engine stop solenoid linkage (1 place) 3-42 WA320PT-5L