MAINTENANCE CONNECTING THE BOOSTER CABLES AND STARTING THE ENGINE Keep the ignition switch of the normal machine and problem machine in the OFF position. Connect the booster cable as follows, in the order of the numbers marked in the diagram. 1. Connect one clip of booster cable (A) to the positive (+) terminal of the problem machine. 2. Connect the other clip of booster cable (A) to the positive (+) terminal of the normal machine. 3. Connect one clip of booster cable (B) to the negative (-) terminal of the normal machine. 4. Connect the other clip of booster cable (B) to the engine block of the problem machine.
STARTING THE ENGINE Always check that the safety lock lever is set to the LOCK po- sition, regardless of whether the machine is working normal- ly or has failed. Check that all the control levers are at the HOLD or neutral position. 1. Make sure the clips are firmly connected to the battery terminals. 2. Start the engine of the normal machine and keep it to run at high idling speed. 3. Turn the ignition switch of the problem machine to the START position and start the engine. If the engine doesn't start at first, wait for at least 2 minutes before trying again.
DISCONNECTING THE BOOSTER CABLES After the engine has started, disconnect the booster cables in the reverse of the order in which they were connected. 1. Remove one clip of booster cable (B) from the engine block of the problem machine. 2. Remove the other clip of booster cable (B) from the negative (-) terminal of the normal machine. 3. Remove one clip of booster cable (A) from the positive (+) terminal of the normal machine. 4. Remove the other clip of booster cable (A) from the positive (+) terminal of the problem machine. Never use a welder or a machine with a higher voltage system to jump start the machine.
Using a higher voltage to jump-start a machine may damage the machines electrical system or cause an unexpected explosion or fire. Always jump-start a machine with equal voltages 3-52 WA320PT-5L