SAFETY MOUNTING AND DISMOUNTING When mounting or dismounting this machine, always be sure the work equipment is fully lowered to the ground and the engine is OFF. Use all hand holds and step plates on your machine. Never jump off or on to the machine. Before getting on the machine, if there is any oil, grease, or mud on your shoes, rails, steps or platforms, wipe it off immediately, always keep these areas clean, and in good condition. Never get on or off a moving machine. These actions may lead to serious injury. Always bring the machine to a full stop. Be sure machine is at a full stop, equipment lowered and parking brake set before entering or exiting machine.
When getting on or off the machine, always face the machine and maintain a Three Point Contact (both feet and one hand or one foot and both hands) with the handrails, steps and platforms to ensure that you support yourself properly. When entering the cab and opening the cab door, push the door open until it is securely into the door klatch (1) and held in position. Use the hand rails on the inside of the door while entering or exiting the cab. Never hold any control levers or the steering wheel when getting on or off the machine. WA320PT-5L 1-5