OPERATION CONTROLS The control levers are used to control the direction and speed of the machine, stop the machine, operate the work equipment and park the machine. A good thorough understanding of these controls will help the operator in using the machine efficiently and safely. DIRECTIONAL CONTROL LEVER Lever (18) is used to change the direction of travel of the machine between forward and reverse. When starting the engine, if the directional lever is not at the N position, the engine will not start. Position (a): FORWARD Position N: NEUTRAL Position (b): REVERSE WORK EQUIPMENT LOCK LEVER Lever (19) is a locking device for the work equipment control levers.
Once the lever is set in the locked position the work equipment will not operate. To set or lock the work equipment push the safety lock lever down to lock it. To release the work equipment for use, pull the lever upward to unlock. Remark When setting the work equipment lock lever in the lock position be sure the work equipment is fully placed on the ground Before leaving the operator's seat, set the work equipment lock lever securely in the LOCK position. If the equipment lock lever is not fully in the LOCK position, and work equipment control levers are touched by mistake, accidental movement of the work equipment may result.
LIFT ARM CONTROL LEVER Lever (20) is used to operate the lift arm. Position (a): RAISE When the lift arm control lever is pulled back the arm is raised. If it is pulled back further from in RAISE position, the lever will lock in this position until the lift arm reaches at a preset position where it stops automatically. Position (b): HOLD When raising or lowering the lift arm by releasing the control lever the arm is kept in the desired position. WA320PT-5L 2-29