If the machine catches fire, it may lead to serious personal injury or death. If a fire occurs during operation, escape from the machine as follows: Turn the starter switch to the "O" (OFF) position and shut down engine. If there is time, use the fire extinguisher to put out as much of the fire as possible. Use the handrails and steps to escape from the machine. The above is the basic method for escaping from the machine, but changing the method may be necessary according to the conditions, so carry out practice drills at the work site.
Protection from Falling or Flying Objects On work sites where there is a danger that falling or flying objects may hit the operator's cabin select a guard to match the operating conditions to protect the operator. Working in mines, tunnels, deep pits or on loose or wet surfaces could produce danger of falling rock or hazardous flying objects. Additional protection for the operator's cabin could be required in the form of a FOPS (Falling Object Protective Structure) or window guards. HAOA110L Figure 10 Never attempt to alter or modify any protective structure reinforcement system, by drilling holes, welding, remounting or relocating fasteners.
Any serious impact or damage to the system requires a complete integrity reevaluation. Reinstallation, recertification and/or replacement of the system may be necessary. Contact your DOOSAN distributor for available safety guards and/or recommendations to prevent danger of getting hit by objects that could strike the operator's cabin. Make sure that all other work site crew members are kept well away from the excavator and safe from possible hazards. HAOA100L Figure 11 For breaker operation, install a front guard and apply a laminated coating sheet to the front glass. Contact your DOOSAN distributor for recommendations.
When carrying out demolition or cutting operation, install a front guard and top guard, and apply a laminated coating sheet to the front glass. When working in mines or quarries where there is a danger of falling rock, install FOPS (Falling Objects Protective Structure) and apply a laminated coating sheet to the front glass. If any glass on the machine is broken, replace it with new glass immediately. OP001759 1-21 Safety