MULTIFUNCTION GAUGE AND GRAPHIC INFORMATION When the engine starter switch is turned to the "I" (ON) position, a LOGO will appear on the display screen for about two seconds. 02/05 [MO] 11:30 When the LOGO disappears, the multifunction gauge and graphic information screen will appear. The engine rpm is normally displayed at the bottom of the screen when the starter switch is first turned "ON." Each time the display selector button (19, Figure 35) is pressed, the digital readout changes in the following sequence; Engine speed (RPM) -> Battery voltage (VOLT) -> Front pump pressure (BAR) -> Rear pump pressure (BAR). E F C H E/G SPEED RPM FG000043 NOTE: See Figure 51 thru Figure 54.
Figure 48 A digital clock is located at the top of the display. By using a combination of the mode selector buttons, information for filters and oils can also be displayed. The display can also be set for the desired language. Refer to the “Setting Main Menu” on page 2-32 for the language selection and information display sequences. Communication Indicator Indicates the condition of communication between main controller and instrument panel. 1. Normal Condition: The symbol will sequentially move like lightening. NOTE: See Figure 51 thru Figure 54. 2. Abnormal Condition: If the symbol is not displayed, it means there is a communication error. FG000047 Figure 49 NOTE: See Figure 50.
OP001760 2-25 Operating Controls