DRESSTA TD20H98/1E — 5.13.5. SERVICING THE RESERVOIR BREATHER

MAINTENANCE SECTION 5 Page 39 5.13. HYDRAULIC SYSTEM WARNING! Fire hazard – do not use kerosene, diesel fuel or flammable liquids to clean parts. A spark or a flame could cause a fire or an explosion. Use a nonflammable commercial solvent. 4. Install the strainer with new O-ring and connect elbow. Fill the system, refer to CHANGING HYDRAULIC OIL. 5.13.5. SERVICING THE RESERVOIR BREATHER Fig. 5.25. Hydraulic Reservoir Breather Location 1. Park the machine on level ground, lower the blade to the ground and stop the engine. Turn the electrical master switch to OFF and remove the key. With the engine stopped, operate the equipment lever several times to relieve any pressure.

Remove all outside dirt from breather. 2. Slowly loosen the filler plug on the reservoir in order to relieve any pressure in the reservoir. WARNING! Pressurized Reservoir. Always loosen the filler plug slowly in case there is still some pressure in the system. 3. Remove the breather (Fig. 26) from the reservoir. Remove the lock ring (1), cover (2), element (3) and clean in a nonflammable commercial solvent. Dry thoroughly. Check O-ring (4) for wear or deterioration. Replace if necessary. Reinstall filter (3) and cover (2). Secure with lock ring (1). Reinstall the filler cap. DRESSTA TD-20H