DRESSTA TD20H98/1E — 5.15.3. ALLOWABLE WEAR OF CUTTING EDGE AND END BITS AND RIPPER POINTS

MAINTENANCE SECTION 5 Page 47 5.15. MOUNTED EQUIPMENT 5.15.2. TRUNNION, COVER, BLADE CUTTING EDGE AND END BITS MOUNTING BOLTS. Check torque of trunnion mounting bolts, bearing cap screws and cutting edge and end bits bolts after initial 10 hours of operation, and then periodically. Fig. 5.35. Tightening Trunnion and Blade Beam Bearing Cap Bolts 1. Cap Bolts 2. Trunnion Bolts Tighten the cap and trunnion bolts to the torque 1050 Nm. Fig. 5.36. Tightening Blade Cutting Edge Bolts 1. Bolt 2. Nut WARNING! Never work beneath the blade without securing it by wooden blocks. 5.15.3.

ALLOWABLE WEAR OF CUTTING EDGE AND END BITS AND RIPPER POINTS Reverse or replace the cutting edge and end bits before the mounting plate is worn or damaged. To replace the cutting edge and end bits: 1. Raise the blade about 300 mm above the ground and set the pilot valve lever in „HOLD” position. Prop up the push arms and stop the engine. DRESSTA TD-20H