DRESSTA TD20H98/1E — 5.18.3.2. SERVICING THE SUCTIO STRAINER

SECTION 5 MAINTENANCE Page 52 5.18. TRANSMISSION SYSTEM 1. With the engine stopped, operate the steering levers several times to relieve any pressure. Open the L.H. side access door. Remove all outside dirt from filter and using a filter wrench remove spin-on filter. Wipe the filter base, removing all of the old oil from the seal area. 2. Coat the seal on the new filter with clean oil. Install the filter by threading it onto the filter base until the seal contacts the base, turn the filter by hand an additional 1/4 to 1/2 turn. Start the engine and let it idle for approximately 5 minutes.

During this time operate the steering levers several times, check filters for leaks and remove leaks if any. 3. Check oil level in the transmission system. Fig. 5.42. Transmission Pressure Filter 1. Filter Seal 2. Filter Element 3. Filter Base 5.18.3.2. Servicing the Suction Strainer After the first 50 hours of operation clean the filter element. Further servicing perform periodically according to „Maintenance Schedule” TD-20H DRESSTA