SECTION 1 INTRODUCTION Page 4 1.1. INTRODUCTION IMPORTANT: This sign and text in italics is used throughout this manual to call your attention to key problems for machine operation. Failure to follow such instructions may result in damage of the machine and heavy material losses. NOTE: This sign and text in italics is used throughout this manual to call your attention to important function having influence on the right functioning of the machine or for informational purposes. 1.2. SERIAL NUMBERS The product identification number (P.I.N.) is stamped on a plate attached to the front wall of the control console at the left hand side of the operator’s seat (Fig. 1.2).
It is also stamped on the rear face of the rear frame in the upper right hand corner (Fig. 1.3). The bulldozer model designation is stamped on the back of the blade, near the top right hand corner (Fig. 1.4). All other components having serial numbers are each equipped with a separate serial number plate. Use serial numbers when requesting information or ordering parts and proper numbers from Parts Catalogue. TD-20H DRESSTA