SECTION 6 SPECIFICATIONS Page 4 6.2. TECHNICAL DESCRIPTION – Pinion / Bevel Gear Set and Steering Drive – Final Drives Engine power is transmitted thru torque converter, universal joint, transmission, pinion / bevel gear set and steering drive to two final drives with mounted sprockets. Three-speed powershift transmission combined with two-speed steering gives 6 speeds forward and 6 speeds reverse or when combined with one-speed steering gives 3 speeds forward and 3 speeds reverse. Steering is accomplished by application of clutch packs in steering drive.
Hydraulics of transmission system Transmission system includes oil tank which is rear frame, suction filter, torque converter mounted pump, main regulator valve, rate of rise valve, range selector valve and transmission and steering drive control valves. Mounted equipment – Semi-U Blade with beams and tilt cylinder (model D-2) – Diagonal Blade with C-frame and tilt cylinders (model G-2) – Straight Blade LGP – Multi-Shank Ripper (max. 3) – Drawbar Blade lift and lower movements are accomplished with two blade lift cylinders. Blade tilt to the right and left is accomplished with one tilt cylinder.
Multi-shank ripper – 3 shanks, tool beam raised and lowered with hydraulic cylinder, ripper shanks are equipped with hydraulic pitch and can be adjusted in two vertical positions. Fixed drawbar with vertical pin. Equipment hydraulic system Equipment hydraulic system consists of hydraulic reservoir with sight gauge and breather, suction filter, hydraulic pump, pilot control valves, control valves with pressure relief valve supplying hydraulic cylinders, quick drop valve and return filters. Hydraulic cylinder operating pressure is 17.5 MPa. TD-20H DRESSTA