SECTION 5 MAINTENANCE Page 6 5.2. SCHEDULED MAINTENANCE GUIDE 5. Check visually water pump for leaking. 6. Check engine mounting bolts and nuts and torque if necessary. * – after initial 1500 hours and then every 6000 hours of operation. Every 2000 hours of operation 1. Replace equipment pilot filter. Refer to 5.13.3. 2. Change hydraulic system oil. Refer to 5.13.2. 3. Clean hydraulic system suction strainer. Refer to 5.13.4. Every 6000 Hours of Operation or every 2 years (Per Engine Operator’s Manual) 1. Drain and flush cooling system. Change coolant. Refer to 5.8.6. Every 6000 Hours of Operation (Per Engine Operator’s Manual) 1. Clean and calibrate injectors. 2.
Clean and calibrate fuel pump 3. Inspect the following engine assemblies: – Turbocharger – Vibration dumper – Fan hub and fan idler pulley – Water pump for oil and coolant leaks 5.2.1. GROUND LEVEL INSPECTION 1. Tractor operational equipment for damage and state of proper fastening. 2. Radiator: for damage, evidence of leakage and condition of grill. 3. Hydraulic components for damage or leakage. 4. Track system: rollers, front idlers, sprockets, track shoes for cracks, excessive wear, loose components and leaks. 5. Transmission system and final drives: for possible leakage. 6. Engine compartment for fuel, oil and coolant leaks. 7. Guards: for damage or missing. 8. ROPS:
general condition (no ROPS defects are permissible that may adversely affect its protection in case of machine rollover). WARNING! To ensure personal protection performs all maintenance services in accordance with Scheduled Maintenance Guide and Instructions. To prolong the service life of your equipment follows the scheduled maintenance listed in Scheduled Maintenance Guide. TD-20H DRESSTA