MAINTENANCE SECTION 5 Page 11 5.4. LUBRICATION 5.4.1. WHEN SHIPPED This machine has been lubricated at the factory for operation in an air temperature range of +21 ° C to – 23°C. If this tractor is to be operated above or below this range, change to the correct lubricants. Unless an exception is shown below, all lubricants can be used (within above temperature range) until regular scheduled (normal) change intervals occur. Refer to „MAINTENANCE AND SERVICE CHART" for the scheduled (normal) change intervals and to "REFILL SPECIFICATIONS AND CAPACITIES CHART" for the proper oil grades for ambient temperatures.
Front idlers, track idlers and track rollers are permanently lubricated with a SAE30, API CD or MIL- L-2104C engine oil. A level check of these compartments is not required. 5.4.2. WHEN SERVICED WARNING! When you service the machine, always follow the Operator's or Service Manual. Never grease, oil or perform any maintenance alone with the engine running. Always have another experienced person helping in the operator's compartment when maintenance must be done with the engine running. Block up all attachments securely. Do not leave the operator's seat with the engine running. Failure to follow these instructions could result in serious injury or death.
The life and performance of a tractor and its equipment depends on the service that it is given. Proper lubrication is an important part of the maintenance service. Thorough lubrication service performed at specified intervals will aid in prolonging the life of the tractor and its equipment and in reducing operating expense. The type of work being done, load, ground and weather conditions are all factors to consider in frequency of lubrication. The scheduled intervals between lubrication periods shown on the „SERVICE CHART” are approximate, based on average operating conditions.
It may be necessary to lubricate after shorter working periods under severe operating conditions such as extremely dusty, low engine temperatures, intermittent operation, excessively heavy loads with high oil temperatures, or when diesel fuel with a high sulfur content is used. However, the time intervals between lubrication periods must never exceed those indicated in this manual. 5.4.3. SELECTION The selection of the proper type (specification) and the grade (weight or viscosity) of lubricant is important. Many tests have been made to determine the correct lubricants for this tractor and its equipment. DRESSTA TD-20H