MAINTENANCE SECTION 5 Page 21 5.7. BELTS To adjust belt tension of alternator proceed as follows: 1. Loosen the clamping bolt „B” of the alternator. 2. Tense the belt with bolt „A” to the tension according to „Belt Tension Chart”. 3. Tighten the bolts clamping the alternator. 5.7.2. BELT TENSION CHART * belt is considered used if it has been run at least 10 minutes. If belt is used for a shorter period of time, apply maximum tension value specified for used belt. Groove width for type K belt is 3.5 mm and 4.3 mm for type L.
DRESSTA TD-20H BELT WIDTH GAUGE NEW BELT TENSION USED BELT TENSION* CLICK BORROUGHS N Lbf Lbf N 0.38” 3822524 140 620 60 – 110 270 – 490 0.44” 3822524 140 620 60 – 110 270 – 490 1/2” 3822524 ST-1138 140 620 60 –110 270 – 490 11/16” 3822524 ST-1138 140 620 60 – 110 270 – 490 3/4” 3822524 ST-1138 140 620 60 – 110 270 – 490 7/8” 3822524 ST-1138 140 620 60 – 110 270 – 490 4-groove 3822524 ST-1138 140 620 60 – 110 270 – 490 5-groove 3822524 ST-1138 150 670 60 – 120 270 – 530 6-groove 3822525 ST-1293 160 710 65 – 130 290 – 580 8-groove 3822525 ST-1293 200 890 80 – 160 360 – 710 10-groove 3822525 3823138 250 1110 100 – 200 440 – 890 12-groove 3822525 3823138 300 1330 120 – 240 530 – 1070 15-groove K 3822525 3823138 375 1670 150 – 300 670 – 1340 16-groove L ----- 3376344 560 2490 260 – 520 1160 – 2315 20-groove L ----- 3823772 700 3115 330 – 650 1470 – 2890