In order to improve the propulsional properties of the tires at the rear axle, on delivery, they are fi lled with water and an additive composed of magnesium chloride which serves as antifreeze. Tires at the rear axle 5 - 26 Issue: 02-10 NOTE! Magnesium chloride is commercially available granulated salt with a 47% share of dry substance which can be purchased at (chemical) wholesale. In countries where the exterior temperatures never fall below 0є C, the tires can be filled with industrial water, without any additives. The saline solution (see Preparation of the saline solution below) can be poured into the tire ( 1 ) by means of a container placed above the tire or via a special pump. NOTE!
Preparation of the saline solution: Mix magnesium chloride and water at a weight ratio of 1:1 in a clean container. Stir until the salt has completely dissolved. Always add the salt to the water, never vice versa. i Lift the compaction roller at the rear axle by means of a sufficiently dimensioned hydraulic jack. The filling procedure ( 5 ) must be interrupted repeatedly because the tire needs to be bled. In case the tire is not suf fie ntly filled after pouring in the saline solution, add industrial water to establish the required level. The fi lling procedure is identical to the one with antifreeze additive, see instructions above.
Turn the tire ( 1 ) until the charge valve ( 2 ) is in the top position. In order to fi ll the tires with water, use industrial water. Filling procedure: Water and antifreeze additive Screw a hose line ( 4 ) onto the charge valve. Slowly unscrew the valve core ( 3 ). Filling procedure: Pure water i 5.3.1 Water filling in the tires of the rear axle 2 1 5.3 Tires at the rear axle 3 4 5 3