WARNING! Material damage! Have tires replaced or mounted by an authorized HYUNDAI dealer or a trained expert only. In order to prevent the tire from sliding on the wheel rim, the tire must not be mounted with the aid of lubricants. In order to check the tire inflation pressure, the charge valve ( 2 ) needs to be in the top ( «12 o`clock» ) position. Move the compaction roller forward and backward to establish this position of the tires ( 1 ). Squeeze the filler valve until there is no saline solution (or water) leaking from the valve ( 2 ) any more. WARNING! Material damage!
Always empty the tires and make sure no water or saline solution can leak from the charge valve before checking the tire in fl ation pressure. Moisture destroys the tire gauge. Tires at the rear axle 5 - 29 Issue: 02-10 DANGER! Risk of injuries! Antifreeze may leak from the tire while its pressure is being checked! This can lead to chemical burns. Wear protective clothing to protect your skin! Standard tires 1.1 bar 1.6 bar With water fi lling Special tires 1.6 bar 2.0 bar With water fi lling Type of tires min. pressure max. pressure Note! Attach the gauge and check the tire inflation pressure. If necessary, adjust the tire pressure. Tightening torque of the wheel nuts ( 2 ): 500 Nm .
Unscrew the safety cap of the charge valve. Check the tire pressure once a week: Checking the tire pressure: 5.3.4 Checking the tire inflation pressure 2 1 5.3.5 Mounting the tires Type of tires min. pressure max. pressure Note! Standard tires 1.1 bar 1.6 bar With water filling Special tires 1.6 bar 2.0 bar With water filling