hyundai — Trainingshandbuch PF2501-2601englisch-02.10-unvollst

. at measuring The drum loses ground contact (i.e. jumps) 7.1.8 Trouble shooting: What to do if the compaction does not start The vehicle does not move in the desired direction Failure / Problem Failure / Problem The compaction roller remains stationary Failure / Problem Causes and actions to be taken The vehicle does not move in the desired direction • Defective contact in the eletrical system • The cable connections or the plug-in connections may be loose or defective. • Check the power supply to the solenoid valve: • Is the solenoid valve charged? • The solenoid valve fails to switch • If so, does the solenoid head switch?

• In case it does, repeatedly change the direction of motion by means of the joystick. • In case it does, but there is still no thrust, check the valve function, see the sections referring to the travel and vibration pump. The compaction roller remains stationary • The parking brake has not been deactivated. • Deactivate the parking brake and actuate the A warning sound is started. joystick. • Electrical fault related to deactivating the parking brake. See chapter Electrical installation. • If, in spite of carrying out the measures above, the compaction roller still does not move, check the position of the relief valve in the hand pump block.

• The emergency actuation for the brake has not been • The solenoid valve for determining the direction of reversed. motion may be defective, see instructions above. • Insufficient charge pressure. Check the pressure at measuring point PS. • The HP valves have not been closed and tightened • Check the high pressure A and B at measuring after a towing process. points MA/MB. The drum loses ground contact (i.e. jumps) • The ground is too hard. • The compaction limit of your vehicle has been reached. Stop the compaction process.