. OPERATION OPERATION CHECK COOLANT LEVEL, ADD COOLANT WARNING CAUTION between the FULL and LOW there is probably coolant the level of the water in the of the same density in density table in "CLEAN (PAGE 4-21)", then add If the volume of coolant added is more than usual, check for possible leakage. Confirm that there is no oil in the coolant. 3 - 104 Do not open the radiator cap unless n ecessary. Wait for the engine to cool down before checking the c oolant in the sub-tank. Immediately after the engine is stoppe d, the coolant is at a high temperatur e and the radiator is under high internal pressure.
If the cap is removed to check the coo lant level in this condition, there is a hazard of burns. Wait for the temperature to go down, then turn the cap slowly to rele When adding coolant, use the step and h andrail provided. Support your body 1. Open the side door of the engine machine. 2. Check that the coolant level is range on sub-tank (1). If the co through the water filler port of su 3. After adding coolant, tighten the 4. If the sub-tank becomes empt leakage. After checking, repair a n radiator according to the COOL INSIDE OF COOLING SYSTE COOLANT to the sub-tank.