Komatsu — CHECK BEFORE STARTING ENGINE, ADJUST

. OPERATION OPERATION ADJUST SEAT BELT Always wear the seat belt. WARNING is worn or damaged, replace it. lengths of the belt on both the buckle and the 3 - 114 Before fastening th e seat belt, check that there is no abnormality in th e belt-mounting bracket or mo unting of the belt. If th e belt Even if there are no signs of damage, replace belts in accordance wi th the te of seat belt manufacture, or e very 3 years after the s tart of actual usage, wh ichever date comes fi Fasten the seat bel t before starting operations. at belt during operations.

Always wear the se Make sure that the left and right belts are not twiste d when fastening the seat REMARK The date of seat bel t manufacture attached to th e seat belt is th e sta rt of the 5-year period . It is not the start o f the 3-year period of act ual usage. FASTENING AND REM OVING BELT hat it is tight without being too tight. depress the brake pedal fully, and adjust t r back is pressed against the backrest. Fasten the belt so t hat it is tight without being to 1. Sit on the seat, seat so that you 2. After adjusting t the tether belt a seat. 3. Sit on the seat, h right hands, ins to check that it i 1.

Sit on the seat, depress the brake pedal full r back is pressed against the backrest. 2. After adjusting t he seat position, adjust teth er belt (1). Ten nd install it when there is no one sitting on t 3. Sit on the seat, h old buckle (2) and tongue (3) with your l eft a ert tongue (3) into buckle (2), then pull t he b s securely locked. 4. When removing the belt, press the red butto n in buckle (2) t o fre Fasten the belt tongue sides so along your body without kin king it. Adjust t he le that the buckle is located at the front, mid-point ADJUST BELT LENGT H To make belt shorte r: Pull the free end of the tet