. OPERATION TRANSPORTATION Lifting work can be carried out only for machines with lifting marks. Before starting the lifting operation, stop the is horizontal, position (L). articulating. NOTICE 3 - 163 machine i n a horizo ntal place an d do as follows. 1. Start t he engin e, make sur e that the mach then s et the wor k equipment to the travel po For de tails, see "MOVING T HE MACHINE ( (A): 40 - 50 cm (16 - 20 in) 2. Check that the work equipm ent control leve r is at the HOLD positio n, then se t the work e quipment lock l LOCK 3.
Stop t he engine , check tha t the area arou nd the operator's compartment is position (L) to safe, then s prevent the et the frame lock front frame and bar to the rear frame LOCK from 4. Use w ire ropes and slings th at match the we ight of the machine, and wind the wire rop e and fix it to the lifting points as shown in the figure . Use prot ectors, etc. so that the w ire ropes will not be broken at sharp Use thre aders and bars having su fficient width so t hat the sling s and wire ropes will not touch the For mac hines equip ped with a re ar full fender, rem ove the rear f ull fender before carrying out the o 5.
Before lifting up the machine , set the slings a nd float the machine to 100 mm - 200 mm ab ove the ground. Make sure th at the wir e ropes are not slack and th e machine i s kept horizontally, and then lift up the machine slowly.