Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE CLEAN INSIDE OF COOLING SYSTEM WARNING Stop the machine on level ground when cleaning or changing the coolant. Komatsu genuine SUPERCOOLANT (AF-NAC) has the important function of preventing corrosion as well as preventing freezing.Even in the areas where freezing is not an issue, the use of antifreeze COOLANT is essential. Komatsu machines are supplied with SUPERCOOLANT (AF-NAC). SUPERCOOLANT (AF-NAC) has excellent anticorrosion, antifreeze and cooling properties and can be used continuously for two years or 4000 hours. As a basic rule, we do not recommend the use of any COOLANT other than SUPERCOOLANT (AF-NAC).

If you use another COOLANT, it may cause serious problems, such as corrosion of the engine and aluminum parts of the cooling system. To maintain the anticorrosion properties of COOLANT, always keep the density of COOLANT between 30% and 68%. When selecting COOLANT, investigate the lowest temperature in the past and decide the density for the COOLANT from the COOLANT density table below. When actually deciding the density for the COOLANT, set it about 10 ° C (18 ° F) below lowest temperature. The density must be over 30% at least.

If the density of obtained COOLANT is higher than the necessary density for lowest temperature, dilute it with adequate distilled water, and then fill it into the tank. If there is any unclear point, please contact your Komatsu distributor. 4 - 21 Immedi ately after the engine i s stopped , the e ngine coolant i s hot and the p ressure insid e the radiato r is high. Removing the cap an d draining t he wate r under this co nditio n could cause burns. Allow t he engine to cool down, t hen turn the cap slowly to relea se the pres sure. Start th e engine an d flush the s ystem. B efore standing up or leaving the op erator's seat, set t he work equipment lock lever to the LO CK position .

For det ails of start ing the engine, see "C HECK BEFOR E STARTING ENGINE , ADJUST (PAGE 3-99)" a nd "STARTING ENGINE (PAGE 3-119)" in t he OPERATION sectio n of th e Operation an d Maintenance Manual. When t he underco ver is removed, there is danger of touching the fan. Never e nter the rea r of the machine whe n the engine is runni Clean the inside of the coolin g system , change the coola nt according to the table below Coolant Interval for cleaning inside of cooling system and changing antifreeze coolant Komatsu genuine SUPERCOOLANT (AF-NAC) Every two years or every 4000 hours whichever comes first