. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE (PAGE 4-40)". REPLACE HYDRAULIC TANK BREATHER ELEMENT WARNING and may cause burns. Wait for the 4 - 59 18. Next, operate the steering, bucket, and lift arm cylinde rs fully 3 - 4 times, then sto p the engine and loos en air bleed p lug (13) After bleeding the air from the hydraulic tank, tighten p lug (13) Keep the engine r unning at low idling w hen bleeding the air. 19. Check that the hyd raulic oil is at the stan dard level. Fo r details see "CHECK OIL 20. Next, raise the en gine speed, repeat th e air bleeding procedure in S tep 18, and continu e the operation u ntil no more air comes o ut from plug (13). 21.
After bleeding the air, tighten plug (13). Tightening torque: 11.3 ± 1.5 Nm (1.15 ± 0.15 kgm, 8 .3 ± 1.1 22. Check that the hyd raulic oil is at the stan dard level. For details, see " CHECK OIL LEVEL IN HYDRAULIC T ANK, ADD OIL (PAGE 4-40)". s no leakage of oil from the filter cover mount. 23. Check that there i s no leakage of oil fro m the filter co ver mount The parts and oil are at high temperature i temperature to go do wn before starting the w When removing the o il filler cap, turn it slowly to release the i nternal p ressur e, then re 1. Before removing t he breather, wipe off all the dirt from around the breather. f oil filler (F). (1) built into the cap. 2. Remove the cap o 3.
Remove breather (1) built into the cap. 4. Replace the filter element (2) built into t he breather wi th a new part, then install b reather (1) to the cap 5. Tighten the cap of