John Deere Series 300 (3029,4039,4045,6059,6068) — John Deere Series 300 (3029,4039,4045,6059,6068) User Manual

REFERENCE ONLY .. I a: RG1B293.3 ·19·11AUG94 ~ > . ~ J q \ z =t ~ ' (!l a: -19-09JUN94 140497 PN=57 Lubrication and Maintenance/400 Hour RG1B293.4 r 49 IMPORTANT: Any time air intake system is opened, it must be checked for leaks before machine is returned to service. (See CHECK AIR INTAKE HOSES in 600 Hour/1-Vear Section.) 3. Using JD281 A, JDE83, or JDG820 Engine Rotation Tool and JDE81-4 Timing Pin, rotate engine in running direction (clockwise viewed from front) until No. 1 cylinder is at TDC Compression stroke. Insert timing pin in flywheel. If No.1 cylinder rocker arms are loose, the engine is at No. 1 ''TDC-Compression''. If No.

1 cylinder rocker arms are not loose, rotate engine one full revolution (360') to No. 1 ''TDC-Compression''. 4. Check and adjust valve clearance to specifications, as directed in the following procedures for 3-, 4-, or 6-cylinder engines. VALVE CLEARANCE (ROCKER ARM-TO-VALVE TIP) SPECIFICATION Intake Valve .......................... 0.35 mm (0.014 in.) Exhaust Valve ..... ... ........ ... ..... 0.45 mm (0.018 in.) 1. Remove rocker arm cover and crankcase ventilator hose. 2. Remove plugs or cover plate from flywheel housing timing holes (A). NOTE: Some engines are equipped with flywheel housings which do not allow use of an engine rotation tool. 5.

If rocker arm is equipped with adjusting screw and jam nut (A), tighten jam nut to 27 N·m (20 Ib-ft) after adjusting valve clearance. CHECK AND ADJUST ENGINE VALVE CLEARANCE Engine valve clearance MUST BE checked and/or adjusted with engine COLD.