REFERENCE ONLY 140497 PN=62 S11.0MLM.DK -19-17FEB93 AG1B293.5 -1S-02AUG94 A-Retaining Ring B-Filter element C-Drain Plug D-Bleed Plug Lubrication and Maintenancel600 Hr11- Yr 54 4. Place filter on filter base with upper seal over spring pin (A) on filter base. 5. Hook bottom end of retaining spring first; then hook the top end. 7. Open fuel shut-off valve and bleed filters. (See BLEED FUEL SYSTEM in Service As Required Section.) Tighten bleed plug (C). 3. When equipped with water separator, remove filter element from glass sediment bowl. Clean sediment bowl and reinstall a new element onto bowl. 5. Hand tighten until the retaining ring fits into the lock position. NOTE:
The proper installation is indicated when a "click" is heard and a release of the retaining ring is felt. 6. Open fuel shut-off valve and bleed fuel system. (See BLEED FUEL SYSTEM in Service As Required Section.) Tighten bleed plug (D). 6. Install drain plug (B). Tighten drain plug securely. 2. Loosen retaining ring (A) and remove filter element (B). 4. Align keys on filter element with slots in filter base. A plug is provided with the new element for plugging the used element. 1. When equipped, close the fuel shut-off valve. A-Spring Pin B-Drain Plug C-Bleed Plug On Round Fuel Filters: