John Deere Series 300 (3029,4039,4045,6059,6068) — John Deere Series 300 (3029,4039,4045,6059,6068) User Manual

REFERENCE ONLY 140497 PN=90 Consult fuel supplier; use proper type fuel for operating conditions. Have authorized dealer or engine distributor check injectors. Have authorized dealer or engine distributor check injectors. Continued on next page Turn key switch to "OFF" then to "ON". See your authorized servicing dealer or engine distributor. Check gauge, sender, and connections. Drain, flush, fill and bleed system. Drain, flush, fill, and bleed system. Use cold weather starting aids. Remove and check thermostat. Remove and check thermostat. Remove and check thermostat. Review starting procedure. See "Starter Cranks Slowly". Use oil of proper viscosity. Add oil to engine crankcase.

Replace filter element. See "Engine Overheats". Replace filter element. Check fuel tank. Bleed fuel line. Solution Troubleshooting Water, dirt, or air in fuel system. Injection pump shut-off not reset. Water, dirt, or air in fuel system. Defective temperature gauge or sender. Impro,?er starting procedure. Dirty or faulty injection nozzles. Dirty or faulty injection nozzles. 82 Crankcase oil too heavy. Injection pump out of time. Low coolant temperature. Engine runs irregularly or Low coolant temperature. stalls frequently DIAGNOSING ENGINE MALFUNCTIONS Slow starter speed. Improper type of fuel. Low engine oil level. Engine overheating. Defective thermostat. Air in fuel line.

Clogged fuel filter. Clogged fuel filter. Cold weather. Problem No fuel. Engine hard to start or will not start Below normal engine temperature Engine knocks Symptom