REFERENCE ONLY Continued on next page 86 140497 PN=94 Remove accessories or install higher output alternator. Increase engine rpm when heavy electrical load is used. Sulfated or worn-out batteries. See your authorized servicing dealer or engine distributor. Clean and tighten loose connections. See your authorized servicing dealer or engine distributor. See your authorized servicing dealer or engine distributor. Inspect and clean as necessary. Check for moisture and replace as necessary. Loose or defective alternator belt. Adjust belt tension or replace belts. Clean and tighten connections. Test charging system. Test charging system. Disengage PTO. Replace fuse. Test battery. Test Battery.
Solution DIAGNOSING ELECTRICAL SYSTEM MALFUNCTIONS Troubleshooting Excessive electrical load from added accessories. Poor electrical connections on battery, ground strap, starter or alternator. Battery charging rate too high. Loose or corroded connections. Loose or corroded connections. Low battery output voltage. Excessive engine idling. Cracked battery case. Faulty start circuit relay. Blown fuse (MDL-25) Defective battery. Defective alternator. Defective battery. PTO engaged. Problem Battery Uses Too Much Water. Batteries will not charge Underch~rged System Starter will not crank Symptom