OPERATIONAL PERFORMANCE TEST / Component Test BRAKE ACCUMLATED PRESSURE (The pressure can be measured by using Dr. ZX.) CAUTION: If air is mixed in the brake system, the brake function is reduced serious hazard may occur. Bleed air from the brake system after removing and installing the pipe lines and replacing hydraulic oil. Refer to the Troubleshooting B in Group T5-6. Summary: The accumulated brake pressure is measured at output port of the accumulator. The accumulated brake pressure varies according to operation of the brake. Record the maximum value. Preparation: CAUTION: Set the block onto the front and rear tires in order not to move machine. Keep away from the machine. 1.
Stop the engine. 2. Push the air bleed valve on top of the hydraulic oil tank and release any remaining pressure. 3. Depress the brake at least 50 strokes in order to reduce the accumulated pressure left in the brake circuit. 4. Remove plug (1) from the pressure check port of charging block in bottom of the cab. Install a nipple and a pressure gauge to the pressure check port. T4GB-04-05-017 Block 1 : 6 mm 5. Start the engine. Check for any oil leaks at the pressure gauge connection. 6. Maintain the hydraulic oil temperature at 50 ± 5 ° C (122 ± 41 ° F). : 19 mm, 22 mm T4GB-04-05-019 T4-5-26