OPERATIONAL PERFORMANCE TEST / Component Test BRAKE WARNING SET PRESSURE (DECREASE) (The pressure can be measured by using Dr. ZX.) CAUTION: If air is mixed in the brake system, the brake function is reduced serious hazard may occur. Bleed air from the brake system after removing and installing the pipe lines and replacing hydraulic oil. Refer to the Troubleshooting B in Group T5-6. Summary: When the warning buzzer sounds by reducing the accumulated brake pressure, measure the pressure at the output port of accumulator. Preparation: CAUTION: Set the block onto he front and rear tires in order not to move the machine. Keep away from the machine. 1. Stop the engine. 2.
Push the air bleed valve on top of the hydraulic oil tank and release any remaining pressure. 3. Depress the brake at least 50 strokes in order to reduce the accumulated pressure left in the brake circuit. 4. Remove plug (1) from the charged pressure check port in brake valve. Install a nipple and a pressure gauge to the pressure check port. T4GB-04-05-017 Block : 6 mm 5. Start the engine. Check for any oil leaks at the pressure gauge connection. 6. Maintain the hydraulic oil temperature at 50 ± 5 ° C (122 ± 41 ° F). : 19 mm, 22 mm 1 T4GB-04-05-018 T4-5-28 Bl ake Valve