hitachi — Introduction

TROUBLESHOOTING / Diagnosing Procedure INTRODUCTION Refer to the inspection and troubleshooting proce- dures after any machine trouble has occurred. The inspection and troubleshooting procedures are pre- sented in an orderly fashion in this section to quickly find the cause of the machine trouble and solution. The troubleshooting section in this manual consists of 8 groups; Diagnosing Procedure, Dr. ZX, e-Wheel, Component Layout, Troubleshooting A (base machine diagnosis by using fault codes), Troubleshooting B (base machine diagnosis starting with inspection of abnormal operational status), Troubleshooting C (monitor diagnosis) and Electrical System Inspection. Dr.

ZX This group contains the operating procedures for Dr. ZX. e-Wheel Refer to these procedures if any fault codes are displayed when ICF (information controller) and satellite communication controller are diagnosed by using Dr. ZX. (ICF and satellite communication controller self-diagnosing functions retain a re- cord of the electrical signal system malfunction in the form of fault codes. At the same time, as the satellite communication controller sends informa- tion onto CAN, the fault code of satellite commu- nication controller can be checked by using ICF.) This group contains as follows.

Download data from ICF and Upload Various setting procedures when starting satellite communication, when installing the satellite communication controller and when replacing ICF Explanation for the satellite communication sys- tem Component Layout Refer to this group when required to check where the components and inner parts are located. Troubleshooting A (base machine diagnosis by using fault codes) Refer to these procedures if any fault codes are displayed when each controller of ICF (informa- tion controller) is diagnosed by using Dr. ZX (or the service mode of monitor). IMPORTANT:

Each controller self-diagnosing function retains a record of the elec- trical signal system malfunction in the form of fault codes. At the same time, as each controller sends in- formation onto CAN, the fault code of all controllers can be checked by using ICF.) ICF records the fault code of each controller and the date when the malfunction occurs. Troubleshooting B (base machine diagnosis starting with inspection of abnormal operational status) Refer to these procedures when no fault codes are displayed after diagnosing the machine with Dr. ZX (or the service mode of monitor). Troubleshooting C (monitor diagnosis) Refer to these procedures when gauges and/or indicators are malfunctioning.

Electrical System Inspection Refer to this group when required to obtain pre- cautions and/or information for the electrical sys- tem inspection. T5-1-1