hitachi — Main Menu Monitor Display (MainController)

TROUBLESHOOTING / Dr. ZX MAIN MENU MONITOR DISPLAY Dr. ZX displays the input signals from switches and sensors and the control signals from MC.

MC List of Monitor Item T5-2-8 Item Data Unit Required Engine Speed Control instruction value of engine speed to ECM min-1 Hydraulic Fan Target Speed Control instruction value to fan flow rate control valve min-1 Actual Engine Speed Detected valve of torque converter input speed sensor min-1 Torque Converter Output Speed Detected valve of torque converter output speed sensor min-1 Medium Gear Speed Detected valve of transmission medium shaft sensor min-1 Transmission Output speed Detected valve of travel speed sensor min-1 Engine Speed Deviation Difference between required engine speed and actual engine speed min-1 Torque Converter Speed Ratio Ratio of the detected value of torque converter output rotation sensor in that of torque converter input rotation sensor No unit Travel Speed Value converted the detected value of travel speed sensor into speed per hour Km/h Pump Pressure Detected value to main pump delivery pressure sensor MPa Pump Displacement Proportional Valve Output Control instruction value to pump displacement proportional so- lenoid valve MPa Hydraulic Drive Fan Proportional Valve Control instruction value to hydraulic drive fan flow rate control solenoid valve mA Ride Control Proportional Valve Output (Optional) Control instruction value to ride control solenoid valve MPa Pump Displacement Proportional Valve FB Feedback value from pump displacement proportional solenoid valve mA Hydraulic Drive Fan Proportional Valve FB Feedback value from hydraulic drive fan flow rate control sole- noid valve mA Ride Control Proportional Valve Output FB (Optional) Feedback value from ride control solenoid valve mA Accelerator Pedal Output value of accelerator pedal V Parking Brake Pressure Detected value of parking brake pressure sensor MPa Pedal Brake Pressure (Low) Detected value of service brake pressure sensor MPa Lift Cylinder Bottom Pressure (Optional) Detected value of lift arm cylinder bottom pressure sensor MPa Lift Cylinder Rod Pressure (Op- tional) Detected value of lift arm cylinder rod pressure sensor MPa Implement Pressure Detected value of implement pressure sensor MPa Boom Angle (Optional) Output valve of lift arm angle sensor V Key Switch Key ON signal from key switch to each controller ON OFF Ride Control Switch (Optional) Continuity status in ride control switch ON OFF A/C Clutch SW Continuity status in air conditioner switch ON OFF Fan Reversing SW Continuity status in hydraulic drive fan reversing switch ON OFF FNR SW Selected status of forward/reverse lever N F R Err N Speed Gear SW Selected status of shift switch 1 2 3 4 Implement FNR SW Selected status of forward/reverse switch N F R Err N Implement FNR Selector SW Continuity status in forward/reverse selector switch ON OFF USS SW Continuity status in up-shift switch ON OFF DSS SW Continuity status in down-shift switch ON OFF Speed Gear Hold SW Continuity status in hold switch ON OFF Selected Speed Gear Selected speed gear R4 R3 R2 R1 N F1 F2 F3 F4 Actual Speed Gear Actual speed gear R4 R3 R2 R1 N F1 F2 F3 F4 Boom Height Kickout SW (Op- tional) Continuity status in lift arm auto leveler switch (raise) ON OFF Boom Height Kickout Setup SW (Optional) Continuity status in lift arm auto leveler switch (raise) set switch ON OFF Ground Stop SW (Optional) Continuity status in lift arm auto leveler switch (lower) ON OFF Ground Stop Setup SW (Op- tional) Continuity status in lift arm auto leveler switch (lower) set switch ON OFF