TROUBLESHOOTING / Troubleshooting B T5-6-12 Parts Function Symptoms in control system when trouble oc- curs. Symptoms in machine operation when trouble occurs. Implement Pressure Sensor • Is installed to piping upper between main pump and control valve. • Sends the signal on pressure to control valve from main pump to MC. • Pressure cannot be detected. • MC makes torque decrease control disabled. • Although engine torque control cannot be operated properly, clear malfunction may not occur except bad fuel consumption. • As torque decrease control cannot be operated, the engine has a load during combined operation of travel and front attachment.
• When travel load is heavy and the front attachment is operated, the engine may be stalled. Negative Control Valve in Control Valve • Supplies front/rear pressures at the orifice in neutral circuit in control valve to the main pump regulator. • As pressure difference becomes large with the front attachment in neutral, the main pump regulator decreases main pump delivery flow rate. • Main pump delivery flow rate cannot be controlled properly. • If pressure difference becomes small, there is no efficiency to the machine operation. In the long and medium terms, fuel consumption may become bad. • If pressure difference becomes large, the front attachment and steering are operated slowly.
Bucket Flow Rate Control Valve in Control Valve (ZW220) • Controls pressure oil flow rate to the bucket cylinder during combined operation of bucket and lift arm in order to operate combined operation smoothly. • Pressure oil flow rate to the bucket cylinder cannot be controlled properly. • Speed ratio during combined operation of front attachment changes. Flow Rate Control Poppet Valve in Control Valve (ZW250) • Controls pressure oil flow rate to the bucket cylinder during combined operation of bucket and lift arm in order to operate combined operation smoothly. • Pressure oil flow rate to the bucket cylinder cannot be controlled properly.
• Speed ratio during combined operation of front attachment changes. • Bucket single operation may become slow. Flow Rate Control Se- lector Valve in Control Valve (ZW250) • Reduces pressure oil flow rate to the bucket cylinder during combined operation of bucket and lift arm raise in order to operate combined operation smoothly. • Pressure oil flow rate to the bucket cylinder cannot be controlled properly. • Speed ratio during combined operation of front attachment changes. • Bucket single operation may become slow. Steering Valve • Controls pressure oil flow rate to the steering cylinder. • The steering cylinder cannot be controlled.
• According to malfunction, the troubles may occur including the steering is operated slowly, the steering is operated without operating the steering hadle, and so on. • When the steering is operated, hunting may occur. Steering Accumulator • Absorbs pulsation in the steering circuit. • Pulsation in the steering circuit cannot be absorbed. • When the steering is operated, hunting occurs easily. Stop Valve • Stops supplying pressure oil to the steering valve from the steering pilot valve when the steering is operated to the stroke end, comes in contact with the frame and closes the valve. • Pressure oil flow rate to the steering valve from the steering pilot valve cannot be controlled.
• When the valve is kept open, although the steering is operated to the stroke end, the steering handle can be operated. • When the valve is kept closed, the steering handle is operated hardly or cannot be operated.