TROUBLESHOOTING / Troubleshooting B T-5 Even if up-shift switch is pushed, travel speed gear is not turned up. Refer to T2-1-34 to 35 in the Control System group/ SYSTEM section. When auto L, N or H in the travel mode selector switch is selected, if the hold switch is pushed, up-shift control is not operated. Travel speed gear cannot be turned up by the up-shift switch beyond travel speed gear selected by the shift switch. Check the wiring connections first. Refer to Troubleshooting A. YES Monitor USS switch of MC monitor item on Dr. ZX. Turn up-shift switch ON. Check if ON is dis- played on screen. NO YES Disconnect connector in up-shift/down-shift switch.
Check if voltage at terminal #2 of harness end of connector is 24 V. NO Execute troubleshoot- ing of each controller by using Dr. ZX. Check if any fault codes are displayed. · Key switch: ON · Key switch: ON NO Faulty fuse or open circuit in harness. · Engine: Running YES Refer to Troubleshooting A. Connector (Harness end of connector viewed from the open end side) Up-Shift/Down-Shift Switch Connector Connector MC-B #2 T183-05-04-021 T5-6-66 1 2 3