TROUBLESHOOTING / Troubleshooting B T-6 Even if down-shift switch is pushed, travel speed gear is not turned down. Refer to T2-1-32 to 33 in the Control System group/ SYSTEM section. When machine travels at faster than travel speed gear, which can decrease, although the down-shift switch is pushed, travel speed gear cannot be turned down. When auto L, N or H in the travel mode selector switch is selected, if the hold switch is pushed, down-shift control is not operated. Check the wiring connections first. Refer to Troubleshooting A. YES Monitor DSS switch of MC monitor item on Dr.ZX. Turn down-shift switch ON. Check if ON is dis- played on screen.
NO YES Disconnect connector in up-shift/down-shift switch. Check if voltage at terminal #2 or #1 of each harness end of connector is 24 V. NO Execute troubleshoot- ing of each controller by using Dr. ZX. Check if any fault codes are displayed. · Key switch: ON NO · Key switch: ON Faulty fuse or open circuit in harness. · Key switch: ON Refer to Troubleshooting A. Connector (Harness end of connector viewed from the open end side) YES Up-Shift/Down-Shift Switch Connector Down-Shift Connector Connector MC-B #2 #1 T183-05-04-021 T5-6-68 9 1 2 3 1 2