TROUBLESHOOTING / Troubleshooting B T-7 Even if hold switch is pushed, travel speed gear is not fixed. Refer to T2-1-38 to 39 in the Control System group/ SYSTEM section. When auto L, N or H in the travel mode selector switch is selected, hold control is not operated. Check the wiring connections first. Refer to Troubleshooting A. YES Monitor hold switch of MC monitor item on Dr.ZX. Turn hold switch ON. Check if ON is dis- played on screen. NO YES Execute troubleshoot- ing of each controller by using Dr. ZX. Check if any fault codes are displayed. · Key switch: ON Disconnect connector in hold switch. Check if voltage at terminal #1 of harness end of connector is 24 V.
NO Faulty fuse or open circuit in harness. · Engine: Running · Key switch: ON NO Refer to Troubleshooting A. YES Connector (Harness end of connector viewed from the open end side) Hold Switch Connector Connector MC-B #1 #B4 T183-05-04-021 T5-6-70 1 2