hitachi — Malfunction of Preheat Indicator

TROUBLESHOOTING / Troubleshooting C MALFUNCTION OF PREHEAT INDICATOR The preheat system operates only when coolant temperature is below the specification. (Refer to the SYSTEM / Electrical Circuit group.) Connector (Harness end of connector viewed from the open end side) In case the preheat system malfunctions, refer to Troubleshooting B. Check the wiring connections first. Faulty coolant temperature sen- sor. YES Preheat indicator lights although pre- heat system does not operate (coolant tempera- ture is more than specification). · Key switch: ON Disconnect con- nector A in ECM. Check if preheat indicator goes out. Disconnect con- nector of coolant temperature sen- sor.

Check if preheat indicator goes out. YES Faulty ECM. YES Shorted circuit in harness between ECM and monitor unit. NO Check for continu- ity between termi- nal #11 of harness end connector A in ECM and vehicle frame. · Key switch: ON NO Faulty monitor controller. NO YES Faulty coolant temperature sen- sor Disconnect con- nector of coolant temperature sen- sor. Short harness end connector. Check if indicator lights. Preheat indicator does not light al- though preheat system operates (coolant tempera- ture is lower than specification). YES Faulty ECM. Disconnect con- nector A in ECM. Connect terminal #11 of harness end connector to vehi- cle frame. Check if preheat indicator lights.

· Key switch: ON Connect terminal #24 of connector 1-B in monitor unit to vehicle frame. Check if preheat indicator lights. YES Open circuit in harness between ECM and monitor controller. NO NO · Key switch: ON NO Faulty monitor unit. · Without disconnect- ing connector, con- nect connector to vehicle frame by using a clip from the rear of connector. ECM Connector A T1GR-05-04-002 T4GB-05-05-002 T5-7-21 Monitor Unit Connector 1-B #24 #11 T