hitachi — Malfunction of Engine Oil PressureIndicator

TROUBLESHOOTING / Troubleshooting C MALFUNCTION OF ENGINE OIL PRES- SURE INDICATOR Although the fault code is not displayed in ECM and if the trouble occurs, conduct this remedy. NOTE: After the engine stops in 1 to 2 minutes, pressure may remain inside. When the en- gine re-starts under this condition, the in- dicator may not light. Disconnect connector A in ECM. Connect terminal #17 of harness end con- nector to vehicle frame. Check if indicator lights. YES YES Connect the disconnected connector. Connect terminal #8 of con- nector 1-A in monitor unit to vehicle frame. Check if indicator lights. Indicator does not light although en- gine oil pressure is low.

Check if indicator lights when key switch is turned to ON position. · Key switch: ON · Without disconnecting con- nector, connect connector to vehicle frame by using a clip from the rear of connector. · Key switch: ON NO · Key switch: ON · Engine: Stopped NO YES Disconnect con- nector A in ECM. Check if indicator goes out. · Check oil filter for clogging. · Key switch: ON · Engine: Stopped Indicator does not go out after engine is started. YES Disconnect con- nector 1-A in moni- tor unit. Check if indicator goes out. NO NO T5-7-30