hitachi — Main Pump Delivery Pressure

OPERATIONAL PERFORMANCE TEST / Component Test MAIN PUMP DELIVERY PRESSURE The main pump delivery pressure can also be meas- ured by using Dr. ZX. Summary: Measure the main pump delivery pressure in order to check performance of the main pump. Preparation: 1. Stop the engine. 2. Push the air bleed valve on top of the hydraulic oil tank and release any remaining pressure. 3. Remove the plug from the main pump delivery port. Install an adapter, a hose and a pressure gauge. Pressure Gauge : 6 mm (If Dr. ZX is used, install Dr. ZX and select the controller function diagnosing.) 4. Start the engine. Check for any leaks at the pres- sure gauge connection. 5.

Maintain the hydraulic oil temperature at 50 ± 5 ° C (122 ± 41 ° F). Measurement: 1. Set engine speed at fast idle. Depress the accel- erator pedal fully. 2. Measure pressure without load (with the control levers in neutral). 3. Repeat the measurement three times and calcu- late the average values. Pressure Check Port T4GB-04-05-008 Adapter Evaluation: Refer to the Performance Standard Table in Group T4-2. Remedy: Refer to Troubleshooting in Section T5. T4-5-6