OPERATIONAL PERFORMANCE TEST / Component Test PARKING BRAKE PRESSURE Evaluation: CAUTION: If air is mixed in the brake system, the brake function is reduced and serious hazard may occur. Bleed air from the brake system after removing and installing the pipe lines and replacing hydraulic oil. Refer to Troubleshooting B in Group T5-6. Summary: 1. Measure the parking brake release pressure in the parking brake release circuit. Preparation: Refer to the Performance Standard Table in Group Remedy: Refer to Troubleshooting B in Group T5-6. T4-2. CAUTION: Set the block onto the front and rear tires in order not to move the machine. Keep away from the machine. 1. Stop the engine. 2.
Push the air bleed valve on top of the hydraulic oil tank and release any remaining pressure. 3. Remove brake hose (1) from the parking brake side. Install a pressure gauge to the removed hose. T4GB-04-05-017 : 19 mm, 22 mm 4. Start the engine. Check for any oil leaks at the pressure gauge connection. 5. Maintain the hydraulic oil temperature at 50 ± 5 ° C (122 ± 41 ° F). Conditions for Measurement: 1. Set engine speed at fast idle. 2. Depress the accelerator pedal fully. Measurment: 1. Release the parking brake and measure the pressure at this time. 2. Repeat the measurement three times and calculate the average values. Block 1 M4GB-06-004 T4-5-24